Programming Control Module (Function 07)
Code Control Module (function 07)
Using this function, the instrument cluster can be coded as follows:
- Market versions
- Distance impulse number
- Available equipment activation
NOTE:
- The code table lists only those combinations applicable to the VW EuroVan.
- Coding adjusts the various combination possibilities according to country version, engine, trip impulse number and optional equipment.
Initiating coding
- Connect VAG 1551 Scan Tool (ST), select operating mode 1 "Rapid data transfer", switch ignition on and enter address word 17 for "instrument cluster"
After control module identification is displayed:
- Press -> button.
Indicated on display:
Rapid data transfer HELP
Select function XX
- Press buttons -0- and -7- to select function 07 "Code Control Module".
Indicated on display:
Rapid data transfer Q
07 - code Control Module
- Press -Q- button to confirm input.
Indicated on display:
Code control module
Enter code numbers XXXXX (0-32000)
- Determine vehicle particulars and input code number using coding table.
Example:
NOTE: Values shown below are examples only!!
03 Available equipment:
Brake pad wear indicator (01) + seatbelt warning (02)
2 Country version: USA
3 Service interval (n/a)
1 Distance impulse number
Indicated on display:
Code control module Q
Enter code number 03261 (0-32000)
- Press -Q- button to confirm input.
Indicated on display:
7D0920901E T4-KOMBIINSTR. VDO X00 ->
Coding 03261 WSC 00000
- Press -> button.
Indicated on display:
Rapid data transfer HELP
Select function XX
NOTE: If instrument cluster was replaced, the CAN-Bus On Board Diagnostic (OBD) Interface -J533- must also be coded
Where applicable, end function:
- Press buttons -0- and -6-. This selects "End Output", function 06.
Indicated on display:
Rapid data transfer Q
06 - End Output
- Press -Q- button to confirm input.
Indicated on display:
Rapid data transfer HELP
Enter address word XX
The tester returns to the "Select function" mode.
Code table:
