With Manufacturer's Scan Tool (VAG)

ERASING DIAGNOSTIC TROUBLE CODE MEMORY (FUNCTION 05)

Test conditions
- Malfunction(s) eliminated

Work sequence
- Carry out road test of at least 10 minutes duration. When doing this
- Make sure that engine coolant temperature reaches at least 80 °C (176 °F)
- Briefly depress accelerator pedal fully when engine speed is above 4600 RPM.
- Accelerate in 4th gear from approx. 50 km/h (30 mph) for approx. 4 seconds using half throttle.
- Connect VAG 1551 scan tool and, with engine idling, insert "Engine Electronics" address word 01. Scan Tool Connecting and Initial Checks


Indicated on display

Rapid data transfer HELP
Select function XX

- Press buttons -0- and -2- to select "Check DTC Memory" function 02.
- Press -Q- button to confirm input.
- Press -> button until all malfunctions still stored have been displayed and the display reads as shown.

Rapid data transfer HELP
Select function XX

- Press buttons -0- and -5- to select "Erase DTC Memory" function 05.
- Press -Q- button to confirm input.

Indicated on display

Rapid data transfer ->
DTC Memory is erased

- Press-> button.


Indicated on display

Rapid data transfer HELP
Select function XX

- Press buttons -0- and -6- to select "End Output" function 06.
- Press -Q- button to confirm input.
- Carry out a further road test and check DTC memory again.
- No malfunctions should be shown