Air Bag Control Module: Service and Repair

Airbag Control Module -J234-, Removing And Installing

Removing
- Disconnect battery Ground (GND) strap.
- Remove trim/footwell - 5 -.

CAUTION: Observe safety precautions for working on airbags.







- Fold bracket - 2 - opposite direction of - arrow - and disconnect connector - 3 - from control module - 1 -.
- Remove nuts - 4 - (qty. 3, 6 Nm) and remove control module from studs.

Installing
- Installation is reverse of removal.
- Switch ignition on.

CAUTION: Make sure no one is in vehicle.

- Connect battery Ground (GND) strap.
- If control module was replaced, it must be coded, adapt (code) components.