Selector Lever

Selector Lever, Disassembling And Assembling
- Remove selector lever.

Disassembling





- Knock out mounting pin for selector lever with a drift.
- Lift pull rod and slide selector gate out of selector lever together with Tiptronic spring mechanism.
- Release coil spring, then remove pull rod and coil spring from selector lever.





Assembling
- Place coil spring -B- onto pull rod -A-.
- Insert pull rod and coil spring in selector lever.

Installation position: Rounded corner (arrow) and sharp edge point in direction of travel.
- Ensure pull rod slides freely on two guides -C- on selector lever.





- Lift pull rod -D- and slide selector gate -B- with Tiptronic spring into selector lever -A-.
- Drive in mounting pin -C- with a drift.
- To secure pin peen two new spots (arrows) at 90° to the existing ones.
- Install selector lever.