Plastic Relay Lever

Plastic Relay Lever

From 05.07 - Plastic Relay Lever





• To remove the relay lever, it is necessary to remove the cable retainer from the selector cable.

This prevents damage to the selector cable.





- Pull the securing mechanism all the way forward in the - direction of arrow 1 - and then unlock it to the left in the - direction of arrow 2 -.

- Press the relay lever forward (in the - direction of arrow 3 -).

Relay Lever with Tab - arrow 1 - (see previous illustration):

- Press the tab - arrow 1 - (see previous illustration) down as far as the stop and remove the relay lever together with the cable retainer. Move it in the operating direction when doing so.

Relay Lever with Clip - arrow 1 -:





- Remove the clip - arrow 1 - and the relay lever together with the cable retainer.

Continuation for All:

The cable retainer must be behind the tab - arrow 2 -.

• The cable retainer may only be removed with the relay lever removed. Refer to => [ Removing the Selector Cable Retainer
from a Plastic Relay Lever ].

• Lubricate the bearing areas and sliding surfaces when installing.

• For the correct grease, refer to the Parts Catalog.

- Press the cable retainer on the relay lever. Refer to => [ Installing the Cable Retainer ].

- Insert the relay lever together with the cable retainer as far as the stop.

• The clip - arrow 1 - secures the relay lever (see previous illustration).

• Make sure it engages securely.

• The cable retainer must be behind the tab - arrow 2 - (see previous illustration).

Removing the Selector Cable Retainer from a Plastic Relay Lever





• The relay lever is removed

- Insert a flat-blade screwdriver - A - between the bushing - B - and the relay lever.

Installing the Cable Retainer





• The relay lever is removed

• The cable retainer may only be installed at the bushing - arrow -.

• The cable retainer must move freely on the relay lever.

• It must be behind the tab - arrow -, refer to => [ From 05.07 - Plastic Relay Lever ].