High Pressure Sensor / Switch: Service and Repair

High Pressure Sensor

Removing

- Remove air intake shroud. Refer to --> [ Intake Housing ] Service and Repair.

- Separator connectors.





- Remove High Pressure Sensor (G65) - 1 - from coolant line in plenum chamber.

• Counterhold the threaded connection with a suitable tool when loosening and tightening.

Installing

Installation is carried out in the reverse order, when doing this note the following:

- Replace O-ring.

High Pressure Sensor (G65) torque is 8 ± 1 Nm.

• Counterhold the threaded connection with a suitable tool when loosening and tightening.