Operation CHARM: Car repair manuals for everyone.

Oil Pressure Sender: Service and Repair






Oil Pressure Switch (F1)

Special tools, testers and auxiliary items required

Socket 24 mm and Jointed Extension (T40175)

Removing

- Remove the noise insulation.

- Remove the left charge air hose - 1 and 2 -.






- Remove the harness connector - 1 - from the bracket and disconnect the connector - arrow - from the oil pressure switch.






Vehicles with a 1 Pin Switch:

- Remove the bolt - B - from the ground cable (ignore the arrows).






Continuation for all Vehicles:

- Remove the oil pressure switch using the socket 24 mm and jointed extension (T40175).






Installing

- Install the oil pressure switch by hand and tighten it to 20 Nm.

In the case of a 1 pin switch, check whether the ground wire is connected.

Further installation is in the reverse order of removal.