Fog Lamp

Fog Lamp

• Illustrations depict removal and installation of left fog lamp. Removal of right fog lamp is performed in the same way.

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

- Remove the mounting bolt - 1 - and unclip cover - 2 - at top - arrow - from bumper cover.





- Remove screws - arrows -.





- Pull fog lamp housing out of bumper while paying attention to the lengths of the connected wires.

- Disengage and disconnect harness connector - arrow -.





Installing:

Install in reverse order of removal, noting the following:

- Tighten the screws to the tightening specification. Refer to => [ Fastener Tightening Specifications, Fog Lamps ] Specifications.

- After completing assembly work, check function of fog lamp.

- Check fog lamp adjustment and adjust if necessary.