Arm/Disarm Switch: Service and Repair

Interior Monitoring Deactivation Switch (E267) and Vehicle Inclination Deactivation Sensor Button (E360)

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

• When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool ((3409), screwdriver) will be positioned, using commercially available adhesive tape.

• To remove the Interior Monitoring Deactivation Switch and Deactivate Vehicle Inclination Sensor Button, anti-theft alarm system must be deactivated.

• The Interior Monitoring Deactivation Switch and Deactivate Vehicle Inclination Sensor Button compose one component.

• Interior Monitoring Deactivation Switch and Deactivate Vehicle Inclination Sensor Button are located in B-pillar trim on driver's side.

The following components are integrated in the Interior Monitoring Deactivation Switch:

• Interior Monitoring -Off- Indicator Lamp (K162)

• Interior Monitoring Deactivation Switch Illumination (L118)

The following components are integrated in the Deactivate Vehicle Inclination Sensor Button:

• Interior Monitoring -Off- Indicator Lamp

• Push Button Illumination (L76)

The Interior Monitoring -Off- Indicator Lamp and Vehicle Inclination Sensor Indicator Lamp (K188) can be checked via output Diagnostic Test Mode (DTM) of Comfort System Central Control Module (J393), refer to => [ Comfort System Central Control Module, Output Diagnostic Test Mode ] Scan Tool Testing and Procedures.

Removing:

- Switch ignition and all electrical consumers off and disengage the key or ignition switch in position 0 (ignition off).

- Carefully pry out Interior Monitoring Deactivation Switch and Deactivate Vehicle Inclination Sensor Button using (VAS 3409) or a screwdriver.





- Disengage harness connector - arrow - and disconnect it.





Installing:

Install in reverse order of removal.