Tensioned Headliner Tensioning Bands

Tensioned Headliner Tensioning Bands

Routing Tensioning Bands

• Always align eyes correctly according to instructions.

• When routing tensioning bands, ensure they do not rub against each other or other components.

• Mark and note routing of tensioning bands and positioning of eyes.

• If possible, remove only one side so the other side can serve as a pattern.






1 Bolt

• The screw is micro-encapsulated and must always be replaced.

• 3 Nm

2 Eye

• Moveable diverting eye for tensioning band.

• Different versions, with and without guide tab.

• - Arrow a - shows direction of eye on bolt points with marking.

3 Marking

• The recessed area - arrow a - in the marking shows the direction of the eye.

4 Seal

• For securing tensioning bands - 5 - to tensioned headliner and roof pillar trim.

• When replacing the tensioning bands, secure the seal to the bands with sealing pliers (VAS 6372).

5 Tensioning band

• Each tensioning band can be replaced separately. Delivered without eyes and seals.

6 Double eye

• Simple tensioning band diverting eye.

7 End eye

• When replacing the tensioning bands, secure the end eyes to the bands with sealing pliers (VAS 6372).