Shift Unit Overview

Shift Unit Overview

• Lubricate the bearings and sliding surfaces with grease (G 000 450 02).






1 Self-Locking, Nut

• 23 Nm

• Always replace.

2 Transmission Shift Lever

• Install so that the master spline aligns with the shift rod.

• Can be replaced with the shift mechanism still installed.

• Installed position => [ Selector Lever/Relay Lever Installed
Position ] Shift Mechanism Overviews.

• Adjust the shift mechanism after installing. Refer to => [ Shift Mechanism, Adjusting ] Adjustments.

3 Sliding Shoe

• Attached into the relay lever => [ (Item 5) Relay Lever ].

4 Bushing

• Not needed for the plastic relay lever.

5 Relay Lever

• Installed position, refer to => [ Selector Lever/Relay Lever Installed
Position ] Shift Mechanism Overviews.

• Adjust the shift mechanism after installation. Refer to => [ Shift Mechanism, Adjusting ] Adjustments.

• Plastic relay lever from 05.07. Refer to => [ Plastic Relay Lever ] Description and Operation.

6 Gear Shift Unit

• Consisting of the gear shift unit shaft and the gear shift cover.

• The components cannot be separated from each other.

• Can be removed and installed with the transmission installed.

• Gear shift unit shaft adapted together with the revised reverse gear selector fork bearing, see => [ (Item 5) Reverse Gear Selector Fork ] Shift Forks.

• Allocation, gear shift shafts. Refer to => [ Allocation, Gear Shift Unit Shafts ].

7 Bushing

• For the gear shift unit shaft.

• Removing and installing, see => [ (Item 16) Bushing ] Transmission Housing.

8 O-ring

• Insert in the groove in the shift cover.

• Install with transmission fluid.

• Always replace.

9 Cap

• For the transmission ventilation.

10 Circlip

• For the relay lever.

• Not on the plastic relay lever.

• Always replace.

11 Selector Shaft Seal

• Removing and installing, refer to => [ Selector Shaft Seal ] Selector Shaft Seal.

Allocation, Gear Shift Unit Shafts