Camshaft Adjustment Valve 1

Camshaft Adjustment Valve 1

Special tools, testers and auxiliary items required

• Torque Wrench (5-60 Nm) (V.A.G 1783)

• TORX Bit Set (V.A.G 1766)

• Ratchet Insert 1/4" (VAS 6234)

• Spring Type Clip Pliers (VAS 5024 A)

Removing

- Disconnect the camshaft adjustment valve 1 (N205) connector - 1 -.





- Loosen the wiring harness - 2 - from the bracket.

- Remove the bolts - 3 -.

• Do not pull out the camshaft adjustment valve 1 by the connector.

- Remove the bolts - arrows - and remove the camshaft adjustment valve 1 out of the housing.





Installing

• The camshaft adjustment valve 1 as well as the housing must be free of dirt and contaminants.

• Remove the new camshaft adjustment valve 1 from its packaging only prior to installation.

CAUTION!
• The camshaft adjustment valve 1 must not be subjected to knocks and impacts.

- Lubricate the seal with engine oil.

- Carefully install the camshaft adjustment valve 1 into the housing and press it perpendicular to the valve axis in by hand until seated.

- Tighten the bolts to 4 Nm.

The rest of the installation is basically a reverse of the removal sequence.