Exhaust System, Installing

Exhaust System, Installing

• Align the exhaust system when cold.

Procedure

- Separate the exhaust system at the clamping sleeve - 1 -.





- Align the clamping sleeve on the front exhaust pipe, allowing for dimension - a -. - Arrow - indicates the direction of vehicle travel. Dimension - a - = 5 mm.





- Tighten the front clamping sleeve nuts to 25 Nm.

• The clamping sleeve threaded connection faces to the right.

• Pay attention to the clamping sleeve position, the ends of the bolts must not protrude beyond the lower edge of the clamping sleeve.





- Then align the muffler, allowing for dimension - a - to the suspension. - Arrow - indicates the direction of vehicle travel. Dimension - a - = 7 to 9 mm.





- Tighten the rear clamping sleeve nuts to 25 Nm.