Transmission Output Speed Sensor, Checking

Transmission Output RPM Sensor, Checking

Special tools, testers and auxiliary items required

• Multimeter (VAG1526) or Multimeter (VAG1715)

• Connector test kit (VAG1594)

• Wiring diagram

Test Prerequisites

• Respective fuses in fuse box (instrument panel, right) must be OK:

• Battery voltage must be at least 11.5 volts.

• Ground (GND) connections to transmission must be OK.

• Selector lever must be in P position.

• Ignition switched off.

Wiring, Checking

- Connect test box to control module wiring harness , connect test box for wiring test.

- Disconnect 8-pin harness connector - arrow 3 -.





- Check wires between test box and 8-pin connector to Transmission Control Module (TCM) for open circuit according to wiring diagram.





Terminal 5 + socket 38

Terminal 6 + socket 50

Wire resistance: max. 1.5ohms

- Also check wires for short circuit to each other.

Specified value: infinit ohms

If no malfunctions are found in wires:

- Replace Sender for transmission output RPM (G195).

- Erase DTC memory of Transmission Control Module (TCM) => [ Diagnostic Mode 04 - Erase DTC Memory ] Diagnostic Mode 04 - Erase DTC Memory.

- Generate readiness code => [ Readiness Code ] Monitors, Trips, Drive Cycles and Readiness Codes.