Exhaust System, Installing

Exhaust System Components

Exhaust System, Installing

• Align the exhaust system when cold.

- Loosen the nuts - 3 and 4 - on the front clamping sleeve - 1 -.





- Align the front clamping sleeve - 1 - to the mark - A - on the front exhaust pipe - 2 - (- arrow - faces in the direction of travel).

• Dimension - a - = => [ Tightening Specification and Installed
Dimension of the Clamping Sleeve ].

• The connections must be at the right and must not project beyond the lower edge of the clamping sleeve.

- Hand tighten the front nut - 3 - on the clamping sleeve.

- Push the exhaust system far enough forward so that the pre-tension at the retaining loop at the rear muffler dimension - a - equals 15 to 17 mm.





- In this position, evenly tighten the nuts - 3 and 4 - on the clamping sleeves. Tightening specification, refer to => [ Tightening Specification and Installed
Dimension of the Clamping Sleeve ].