Through 2009

MFD 2 Navigation Radio

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)

• Replacement part number for radio navigation system is located on a sticker on the radio navigation system housing.

• Deactivate the anti-theft coding when replacing the radio. Refer to => [ Electronic Anti-Theft
System, Deactivating ] Through 2009. Give the customer the new radio code.

• If the radio code is not known, you can retrieve it via the known systems. It is on a sticker attached to the side of the radio/navigation system. The identification number is also stamped in the material in the side of the radio navigation system.

• If a radio navigation system from one vehicle is to be installed in another vehicle, then always make sure that radio navigation systems of both vehicles have the same replacement part number. Otherwise navigation system will malfunction since the setting of the rotation angle sensor in radio navigation system does not match the vehicle.

Removing

- If there is a CD/DVD still in the unit, remove it.

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove the upper cover and vents from the center of the instrument panel. The screws under the center console should now be accessible.

- Remove screws - arrows - (1.5 Nm).






- Pry off the cover in the center console using a (3409) - arrows -.






- Remove the screws - arrows - (1.5 Nm) on the radio/navigation display unit control module.






- Pull the radio/navigation display unit control module out of the installation slot just far enough until the connectors on the back are accessible.

- Press together the connector lock in direction of - arrows -.






- Then swing mounting bracket up in direction of - arrow - and disconnect harness connector.






- Disconnect the connectors - arrows - from the antenna connections.






Installing

- Connect the connectors to the radio/navigation display unit control module.

- Install the radio/navigation display unit control module into the instrument panel.

• Never push on the display or the buttons on the radio/navigation display unit control module when installing it. It will be damaged.

- Attach the radio/navigation display unit control module with 4 screws - arrows - (1.5 Nm).






- Install the cover in the center console.

- Deactivate the anti-theft coding. Refer to => [ Electronic Anti-Theft
System, Deactivating ] Through 2009.

- Check the radio/navigation display unit control module coding. Code it again if necessary. Refer to => [ MFD 2 DVD Components, Adapting ] MFD 2 DVD Components, Adapting.