Accelerator Pedal Module

Accelerator Pedal Module

Special tools, testers and auxiliary items required

• Release tool (T10238)

Removing

- Remove the nuts - arrows - and remove the footwell trim.





- Pry out the cap using a screwdriver.

- Remove the bolt.

- Slide the (T10238) as shown into the openings designated for it until it stops and remove the accelerator pedal module.





- Disconnect the electrical connector from the accelerator pedal module.

Installing

- Connect the electrical connector - 2 - to the accelerator pedal module - 5 - and slide the rubber grommet - 1 - onto the connection.





- Press the accelerator pedal module onto the studs - 6 -.

- Insert the centering pin - 7 - into the hole on the floor.

- Secure the accelerator pedal module with the bolt - 3 -.

• Tightening specifications, refer to --> [ Accelerator Pedal Module Assembly Overview ] Accelerator Pedal Module Assembly Overview.

- Install the cap - 4 -.

- Install the footwell trim and nuts - arrows -.