Accelerator Pedal Module

Accelerator Pedal Module

Special tools, testers and auxiliary items required

• Release tool (T10238)

Removing

- Remove the steering column cover retainers - arrows - and cover.





- Pry out the cap - 3 - with a screwdriver.





- Remove the bolts - 2 -.

- Disconnect the electrical connector - 1 - - arrow - and remove it from the accelerator pedal module.

- Slide the (T10238) as shown, into openings designated for it until it stops and remove accelerator pedal module.





Installing

- Connect the electrical connector - 1 - to the accelerator pedal module - 4 -. Lock the connector - arrow -.





- Press the accelerator pedal module onto the securing studs - 5 -.

- Insert the centering pin - 6 - into the hole on the vehicle floor.

- Secure the accelerator pedal module with the bolt - 2 - and install the cap - 3 -.

- Reinstall the steering column cover and retainer - arrows -.





- If accelerator pedal module was replaced, adapt the accelerator pedal module to the Engine Control Module (ECM). Refer to --> vehicle diagnosis, testing and information system (VAS 5051) "Guided Functions".

- If accelerator pedal module was replaced in vehicles with an automatic transmission, the kick down function must be learned. Refer to --> vehicle diagnosis, testing and information system (VAS 5051) "Guided Functions".

Tightening Specifications