Shift Lever and Shift Housing through 10.06, Servicing
Shift Lever and Shift Housing through 10.06, Servicing
• Lubricate bearing areas and slide surfaces with grease (G 000 450 02).
1 Lock washer
• Removing and installing --> [ Removing and installing lock washer ]
2 Bushing
3 Spring
4 Bushing
5 Torx bolt, 5 Nm
6 Cover
7 Damper
8 Damper
9 Bearing shell
10 Shift lever guide
11 Damping washer
12 Gasket
• Between shift housing and floor
• Self-adhesive
• Adhere to shift housing
13 Selector lever
14 Shift housing
15 Bushing
16 Pivot pin
17 Guide bushing
18 Spring
• Installing --> [ Installing spring ]
19 Selector bracket
20 Torx bolt, 5 Nm
21 Gasket
• Always replace
22 Base plate
• Bend open tabs to remove
• Always replace
23 Selector cable
• On selector bracket
• Removing and installing --> [ Removing and installing selector cable and
shift cable ]
24 Shift cable
• Removing from shift lever guide and installing on shift lever guide --> [ Removing and installing selector cable and
shift cable ]
25 Lock washer
• Always replace
26 Nut M8, 25 Nm; Nut M6, 8 Nm
• Quantity: 4
27 Bushing
• Only fits in one position
28 Lock washer
• Always replace
Removing and installing selector cable and shift cable
- Remove retaining disc from shift cable - A - and selector cable - B -.
To do this, lift up retainer using a screwdriver - arrow 1 - and press off locking washer - arrow 2 -.
- Remove shift cable - A - from shift lever mount.
- Remove selector cable - A - from selector elbow mount.
Removing and installing lock washer
- To remove and install lock washer - arrow A -, push spacer bushing - arrow B - to stop with a screwdriver in direction of - arrow C - and pull off lock washer.
• Do not tilt bushing when pushing down.
• Groove in shift lever for lock washer must be visible.
• Carefully release tension on spring.
Installing spring
- Insert spring so that leg - A - contacts upper part of pin - arrow -.
- Then pull leg - B - far enough downward so that it rests on the underside of the pin - arrow -.