B1648

B1648 - Rear Right Turn Lamp Control Circuit High






For a complete wiring diagram, refer to.

• When Monitored: Continuously.

• Set Condition: When the totally integrated power module detects a high condition.






Test Step 1 - Test For Intermittent Condition

• Turn the ignition ON.

• With the scan tool, clear all DTCs.

• Turn the right turn signal ON.

• With the scan tool, read DTCs.

Does the scan tool display B1648 - Rear Right Turn Lamp Control Circuit High?

Yes

• Go to Test Step 2.

No

• The condition that caused this symptom is currently not present. Test for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

Test Step 2 - Test Ground Circuits

• Turn the ignition OFF.

• Disconnect the right rear turn signal lamp assembly harness connector.

• With a test lamp connected to 12 volts, probe each ground circuit.

Does the test lamp illuminate brightly on each ground circuit?

Yes

• Go to Test Step 4.

No

• Go to Test Step 3.

Test Step 3 - Ground Circuit Open

• Measure the resistance of the appropriate ground circuits at the right rear turn signal lamp assembly harness connector.

Is the resistance less than 10.0 ohms?

Yes

• Replace the inoperative bulb. .

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

No

• Repair the appropriate ground circuits for an open.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

Test Step 4 - Test Right Rear Turn Signal Control Circuit

• Turn the ignition ON.

• With the right turn signal ON and the test lamp connected to ground, test the right rear turn signal control circuit.

Does the test lamp blink brightly from ON to OFF with the turn signal indicator?

Yes

• Replace the inoperative bulb. .

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

No

• Go to Test Step 5.

Test Step 5 - Right Rear Turn Signal Control Circuit Open

• Turn the ignition OFF.

• Disconnect the TIPM harness connector.

• Measure the resistance of the right rear turn signal control circuit between the right rear tail lamp assembly harness connector and the TIPM harness connector.

Is the resistance less than 10.0 ohms?

Yes

• Go to Test Step 6.

No

• Repair the circuit for an open.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

Test Step 6 - Right Rear Turn Signal Control Circuit Short to Voltage

• Turn the ignition ON.

• Measure for voltage on the right rear turn signal control circuit.

Is there any voltage present?

Yes

• Repair the circuit for a short to voltage.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

No

• Replace the totally integrated power module.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior