B17BA

B17BA - Headlamp Leveling Motor Control Circuit Overcurrent

For a complete wiring diagram, refer to.

• When Monitored: Continuously.

• Set Condition: When the totally integrated power module detects an overcurrent condition.






Test Step 1 - Test For Intermittent Condition

• Turn the ignition ON.

• With the scan tool, clear all DTCs

• Turn the headlamps ON.

• With the scan tool, read DTCs.

Does the scan tool display B17BA - Headlamp Leveling Motor Control Circuit Overcurrent?

Yes

• Go to Test Step 2.

No

• The condition that caused this symptom is currently not present. Test for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

Test Step 2 - Headlamp Leveling Motor Control Circuit Short to Ground

• Turn the ignition OFF.

• Disconnect the TIPM harness connector.

• Disconnect the headlamp harness connector.

• Measure the resistance between ground and the headlamp leveling motor control circuit.

Is the resistance more than 10k ohms?

Yes

• Go to Test Step 3.

No

• Repair the headlamp leveling motor control circuit for a short to ground.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

Test Step 3 - Headlamp Leveling Motor Control Circuit Short to Voltage

• Turn the ignition ON.

• Measure for voltage on the headlamp leveling motor control circuit.

Is there any voltage Present?

Yes

• Repair the headlamp leveling motor control circuit short to voltage.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior

No

• Replace the totally integrated power module.

• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior