B25A4
B25A4-00-Front Right Door Handle Sensor
For a complete wiring diagram, refer to.
• Before proceeding, check the handle for any foreign material, or binding that could cause a sticking situation to the handle or switch.
• When Monitored: During a Passive Entry Event.
• Set Condition: If the hall sensor in the handle stays active for longer than 120 seconds, this code will set.
Test Step 1 - TEST FOR INTERMITTENT CONDITION
• If there are any other PEM DTCs, perform the diagnostic procedure for them before proceeding.
• Turn the ignition on.
• Using the scan tool, record and erase the DTCs.
• Open the Right Front window.
• Turn the ignition off and close all doors.
• Have the FOBIK outside the car and within six (6) feet of the handle.
• Lock and Unlock the Right Front Door by the outside handle four times.
• Open the Right Front Door by pulling the handle.
• Turn the ignition on.
• Using the scan tool, read the Active DTCs.
Does the scan tool display: B25A4-00-FRONT RIGHT DOOR HANDLE SENSOR?
Yes
• Go to Test Step 3
No
• Go to Test Step 2
Test Step 2 - DOOR HANDLE
In the previous step, did the Right Front Door Handle lock and unlock the door as it should?
Yes
• Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior
No
• Go to Test Step 3
Test Step 3 - DOOR HANDLE OR PEM
• Go to the Left Front Door.
• Open the Left Front Window.
• Turn the ignition off and close all doors.
• Have the FOBIK outside the car and within six (6) feet of the handle.
• Lock and Unlock the Left Front Door by the outside handle four times.
• Open the Left Front Door by pulling the handle.
Did the Left Front Door Handle lock and unlock the door as it should?
Yes
• Replace the Right Front Door Handle.
• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior
No
• Replace the PEM Module.
• Perform the Body Verification Test. Refer to => Non-DTC Based Diagnostics. Body Interior