Power Liftgate Full Open Switch

Power Liftgate Full Open Switch

Removing

- Open the liftgate.

- Disconnect and isolate the battery negative cable.

- Remove the power liftgate drive unit. Refer to => [ Power Liftgate Drive Unit ] Power Liftgate Drive Unit.


Mark the position of the two full open switch wire terminals (2) in relation to their location in the liftgate drive unit wire connector (1).

- Using an appropriate wire terminal tool, carefully remove the full open switch wire terminals (2) from the liftgate drive unit connector (1).






- Remove the full open switch screw (3) from the drive unit (1).






- Carefully remove the full open switch wire harness routing clips (2) from the power liftgate drive unit (1).






- Remove the full open switch and wire harness.

Installing


Be certain the wires are reinstalled in the correct wire cavities. Failure to do so could result in damage to components.

- Position the full open switch (2) onto the power liftgate drive unit (1) and install the screw (3).






- Ensure the full open switch wire harness (3) is routed properly through the power liftgate drive unit routing tabs (2).






- Carefully install the full open switch wire harness routing clips (2) into the power liftgate drive unit (1).






- Insert the full open switch wire terminals (2) into the liftgate drive unit connector (1) ensuring the proper terminal location as noted in the full open switch removal procedure.






- Install the power liftgate drive unit. Refer to => [ Power Liftgate Drive Unit ] Power Liftgate Drive Unit.

- Connect the battery negative cable.

- Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.

- Perform the power liftgate learn cycle. Refer to => [ Power Liftgate Learn Cycle ] Power Liftgate Learn Cycle.

- Verify power liftgate system operation.