Power Seat System Verification Test

Power Seat System Verification Test

Test Step 1 - Perform Power Seat System Verification Test

• Disconnect all jumper wires and reconnect all previously disconnected components and connectors.

• Ensure that all accessories are turned off.

• Ensure that the battery is fully charged.

• Turn the ignition ON.

• If either the memory seat module or the driver horizontal seat adjuster motor/seat track was replaced, the memory seat module standard routine must be performed using the scan tool.

• With the scan tool, record and erase DTCs from all modules.

• Operate the driver seat in all positions.

• With the memory switch on the driver door, program the driver seat No. 1 Button to a desired position and driver No. 2 Button to a different position.

• Verify that both memory positions can be recalled from the RKE transmitter and the memory switch on the driver door.

• Turn the ignition OFF, wait 10 seconds, and then turn the ignition ON.

• With the scan tool, select ECU View.

• Check for DTCs in the modules.

Are DTCs present in any of the modules or is the original condition still present?

Yes

• The repair is not complete. Refer to the appropriate information for the DTC or symptom that is still present.

No

• The repair is complete.