HVAC Verification Test

HVAC Verification Test

Perform the following procedures to verify that the repair(s) are valid:

- Make sure that all accessories are turned off.

- Make sure that the battery is fully charged.

- Turn the ignition off to the lock position.

- Disconnect all jumper wires and reconnect all previously disconnected components and connectors.

- With the scan tool, record and erase all Diagnostic Trouble Codes (DTCs) from ALL modules.

- Turn the ignition off, remove the scan tool from the DLC (Data Link Connector). Open the door and close the door. Wait a minimum 30 seconds, then turn the ignition on. Reconnect the scan tool.

• Disconnecting the scan tool and opening and closing the door will allow the controller to enter into sleep mode.

- With the scan tool perform the HVAC Actuator Calibration Test.

- Start and run the engine for two minutes while operating all functions of the system that caused the original concern.

- With the scan tool, check for DTCs in all modules.

Is the original condition still present or are there any other HVAC DTCs present?

Yes

• The repair is not complete. Refer to the related category for the DTC or symptom that is still present.

No

• Repair is complete.