Toe

Toe

- Center the steering wheel and lock in place using a steering wheel clamp.

• Perform the following steps to each side of the vehicle as necessary.


Do not twist inner tie rod-to-steering gear boots during front wheel Toe adjustment. Remove boot clamps at the inner tie rods and make sure boots moves freely on inner tie rod.

Outer Tie Rod At Knuckle





- Loosen jam nut (3) at inner-to-outer tie rod connection.

- Grasp inner tie rod at serrations (4) and rotate as necessary to adjust front toe to preferred toe specification. Refer to => [ Wheel Alignment ] Wheel Alignment.

- Tighten tie rod jam nut (3) to specifications. Refer to => [ Tie Rod, Outer ] Tie Rod, Outer.

- Make sure inner tie rod-to-steering gear boot is not twisted, then reinstall boot clamp at inner tie rod.

- Adjust front toe on opposite side of vehicle using above procedure as necessary.

- Remove steering wheel clamp.

- Remove alignment equipment.

- Road test vehicle to verify steering wheel is straight and vehicle does not wander or pull.