Front Door Glass

Front Door Glass

• Left side shown. Right side similar.

Removing

• If the door glass will not move in the door, remove the regulator motor and manually position the window regulator and glass to the 3/4 up position.

- With the door glass in the 3/4 up position, remove the front door trim panel.

- Remove the round close out plug (1) from the carrier plate (2).






• Illustration shown with carrier plate removed for clarity.

- Remove the door speaker from the door.

- Working through the close out plug and speaker holes in the carrier plate, carefully disengage the front door glass (1) from the two plastic retainer clips (2) located on the window regulator (3).







Use care when removing the door glass to prevent breakage. Do not force the glass out of the door. Failure to follow this warning may result in serious injury.

- Remove the front door glass (1) from the window opening. Tip the front of the glass downward to disengage the glass from the glass run and then lift the glass out of the opening.






Installing

• If the door glass did not move in the door using with power window switch, replace the regulator and/or the regulator motor or repair the electrical concern prior to installing the door glass.

- Install the front door glass (1) into the window opening. Tip the front of the glass downward to engage the glass onto the glass run and then carefully lower the rear of the glass into the door. Make sure the glass is properly positioned within the glass run.






• Illustration shown with carrier plate removed for clarity.

- Working through the close out plug and speaker holes in the carrier plate, carefully engage the front door glass (1) into the two plastic retainer clips (2) located on the window regulator (3).






- Install the door speaker.

- Install the close out plug (1) onto the carrier plate (2).






- Install the front door trim panel.