Navigation Module: Service and Repair

Radios and Radio Navigation Systems

• Use the chapter for the individual unit when removing and installing.

RCD 310 radio system, refer to=> [ RCD 310 ] RCD 310.

RCD 510 radio system, refer to=> [ RCD 510 ] RCD 510.

RNS 315 radio navigation system, refer to=> [ RNS 315 Radio Navigation System ] RNS 315 Radio Navigation System.

RNS 510 radio navigation system, refer to=> [ RNS 510 Radio Navigation System ] RNS 510 Radio Navigation System.

Removal

Do the following before starting the procedure:

- Remove any CD's still in the unit. Refer to the Owner's Manual.

- Turn off the ignition and all electric consumers and remove the key.

- Remove trim in center of instrument panel.

- Remove the screws - arrows - from the radio.






- Pull the radio out just far enough until the connectors on the back are accessible.

Connectors - 1 - through - 6 -:






1 Multi-pin connector, connector housing
2 Connector, navigation antenna
3 Connector, radio antenna
4 Connector, radio antenna
5 Multi-pin connector for video signals
6 Connector, rearview camera video signal

• The number and location of the connections on the unit will vary between the different radios and radio/navigation systems.

- Squeeze the tabs on the multi-pin connector - arrow -.






- Move the retainer in direction of the - arrow -. The connector will be pushed out at the same time.






- Push the retainer - A - onto the audio/video connector and move the mount in direction - B -. The connector will be pushed out at the same time.






- Unlock the antenna connections - arrows - and disconnect the connectors.






Installation

- Connect the connectors to the radio.

- Slide radio straight into instrument panel.

• While sliding in the radio, under no circumstances press on the display or control buttons since the radio may be damaged by doing this.

- Attach the radio with the 4 bolts - arrows -.






- Reinstall center instrument panel trim.

The rest of the installation is performed in the reverse order.

- Deactivate the anti-theft coding if necessary:

Radio system RCD 310, refer to => [ Anti-Theft Coding, Deactivating, RCD 310 ] Anti-Theft Coding, Deactivating, RCD 310.

Radio system RCD 510 refer to => [ Anti-Theft Coding, Deactivating, RCD 510 ] Anti-Theft Coding, Deactivating, RCD 510.

Radio Navigation System RNS 315 refer to => [ Anti-Theft Coding, Deactivating, RNS 315 ] Anti-Theft Coding, Deactivating, RNS 315.

Radio Navigation System RNS 510 refer to => [ Anti-Theft Coding, Deactivating, RNS 510 ] Anti-Theft Coding, Deactivating, RNS 510.

- Check radio/radio navigation system coding and code it if necessary.

For coding and adapting the radio components, refer to => [ Radio Components, Adapting ] Programming and Relearning.

For coding and adapting the radio/navigation components, refer to=> [ Navigation System Components, Adapting ] Programming and Relearning.

Troubleshooting

The radio is equipped with OBD.

To fault find, use "Guided Fault Finding" in the (VAS5051B).