Preparing for Calibration

Preparing for Calibration






1 Volkswagen Logo

• The laser point is aligned on the center of the Volkswagen logo.

2 Wheel Center Sensor (VAS 6350/1)

3 Right-Side Angle Bracket For Mounting Measuring Unit For Distance Measurement

4 Calibration Tool For Lane Changing Assist (VAS 6350/4)

• Distance between the angled brackets on the calibration device (=> [ (Item 3) Right-Side Angle Bracket For Mounting Measuring Unit For
Distance Measurement ] or => [ (Item 9) Left-Side Angle Bracket For Mounting Measuring Unit For Distance Measurement ] ) and the paddles on the rear wheel center wheel mounts: 1.2 m - 1.7 m - dimension A -.

5 Plastic Foot

• Total of three on the bottom side of the calibration device.

• Adjustable in order to adjust the horizontal position of the calibration device.

6 Spacing Laser (VAS 6350/2)

• Notes on operation, refer to operating instructions.

7 Line Laser (VAS 6350/3)

• Switching on and off, refer to the operating instructions.

8 Level On The Calibration Device

• To check the horizontal position of the calibration device.

9 Left-Side Angle Bracket For Mounting Measuring Unit For Distance Measurement

10 Wheel Center Sensor (VAS 6350/1)