Through 06.04

Through 06.04

Through 06.04, the central locking and anti-theft alarm system antenna is integrated in the wiring harness to the headlamps under the right front fender.

• It is not possible to repair the antenna, since this would impair the reception quality.

• If damaged, it is necessary to replace the central locking and anti-theft alarm system antenna.

• The new antenna is not placed in the original location but is routed in another location in the center of the instrument panel instead.

Removal

- Loosen the antenna wire contact from the connector housing on the Access/start authorization control module (J518).

Installation

- Secure the contact on the new antenna in the same location in the connector housing.

- Remove the storage compartment in the center of the instrument panel.

- Route the new antenna wire from the connector housing to the Access/start authorization control module (J518) along the existing wiring harness to the location of the storage compartment in the center of the instrument panel.

• The old antenna wrapped in the wiring harness remains unconnected in the vehicle and is not removed.

• Secure the new antenna wiring on the existing wiring harness to prevent rattling noises.

- Apply a strip of Velcro (15 mm x 190 mm) - 1 - in the location illustrated in the instrument panel.






- Wrap the end of the antenna wire - 2 - with a fleece band and secure it on the Velcro fastener as illustrated.