Lower Engine Cover, Removing and Installing

Lower Engine Cover, Removing and Installing

• On some vehicle equipment versions, the engine compartment is equipped with an additional underbody impact guard from below. Refer to => Body Exterior 50 Removal and Installation

Front Noise Insulation Cover:

• In the illustration, the fittings on the left hand side of the noise insulation is located in front. The fittings on the right-hand side are similar.

• For removing the noise insulation cover, screws must be removed.

- Remove screws - 1 - and - 2 -





Front And Rear Noise Insulation

- Remove bolts - A -.





- Remove noise insulation - 3 -

- Remove screws - B -.

- Remove the rear noise insulation - 2 - out of the spring latches - 1 -.

- Tighten bolts to torque of 8 Nm.