Airbag Control Module

Airbag Control Module

Removing

CAUTION!
When working on the airbag control module (J234) always read the Safety Instructions for working with airbags, belt tensioners and battery cut-out units. Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units, General Safety Precautions ] Airbag, Belt Tensioner and Battery Cut-Out Units, General Safety Precautions.

- Disconnect batteries.

- Remove center console storage compartment. Refer to => [ Center Console Storage Compartment ] Center Console Storage Compartment.

- Remove shifter cover. Refer to => [ Shifter Cover ] Shifter Cover

- Move the locking lever - 1 - away from the connector - 2 - - arrow - and disconnect the connector from the control module - 3 -.

- Remove three nuts - 4 - (9 Nm).

- Remove the control module from the vehicle.





Installation

- To install, perform the steps used for removal in reverse order.

- Switch on ignition.

CAUTION!
Make sure that no persons are in the vehicle.

- Connect battery.

- If the control unit was replaced, it must be coded. Adapting components (coding). Refer to => [ Components, Adapting ] Components, Adapting