Side Airbags Crash Sensors

Side Airbags Crash Sensors

• Removal and installation is described for the right-hand side of the vehicle. Removal and installation for the left-hand side is performed in the same manner.

Removing

CAUTION!
Read the Safety Instructions for working with airbags, belt tensioners and battery cut-out units. Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units, General Safety Precautions ] Airbag, Belt Tensioner and Battery Cut-Out Units, General Safety Precautions.

- Remove belt anchor. Refer to => [ Belt Anchor ] Belt Anchor.

- Remove front seat:

• Remove 12-way seat => [ 12-way Seat ] 12-way Seat.

- Remove seat base. Refer to => [ Seat Base ] Seat Base.

- Remove floor covering in area of side crash sensors.

- Remove the two bolts - 1 - (9 Nm).

- Disconnect the wiring harness - 3 - from the crash sensor - 2 -.





Installation

- To install, perform the steps used for removal in reverse order.

- Switch the ignition on.

CAUTION!
Make sure that no persons are in the vehicle.

- Connect battery ground (GND) strap.