Electrical Accessory Panel: Service and Repair
Left Plenum Chamber E-Box
When disconnecting and connecting the battery, always perform the work procedure as described in the repair manual. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting. Not adhering to sequence will result in the deactivation of Main Battery Switch -E74- and subsequent damage to electrical system components.
Removal
When disconnecting battery, procedure must always be followed as described in => [ Disconnecting Sequence ] One-Battery Layout with Auxiliary Battery and Two Battery Layout, Disconnecting and Connecting.
- Disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.
- Remove driver's side wiper arm. Refer to => [ Driver Side Wiper Arm, Removing ] Driver Side Wiper Arm, Removing
- Remove front passenger's side wiper arm. Refer to => [ Passenger Side Wiper Arm, Removing ] Passenger Side Wiper Arm, Removing
- Remove plenum chamber cover. Refer to => [ Plenum Chamber Cover, Removing ] Plenum Chamber Cover, Removing.
- Remove mounting bolts - arrows - and remove E-Box cover.
• The number of multi-pin harness connectors - 2 - can deviate from the illustration depending on vehicle equipment.
- Disconnect multi-pin harness connectors - 2 - and remove housing gasket - 1 - upward out of E-Box.
• The number of multi-pin harness connectors - 3 - and number of threaded connections - 1 - can deviate from the illustration depending on vehicle equipment.
- Loosen threaded connections - 1 - of supply wires and remove them from connecting pins.
- Unclip connector - 2 - from E-Box.
- Disconnect multi-pin harness connectors - 3 - and remove housing gasket - 4 - upward out of E-Box.
- Remove mounting bolts - arrows - from upper section of E-Box.
- Remove upper section of E-Box upward.
- Unclip lower section of E-Box from vehicle.
Installation
Install in reverse order of removal, observing the following:
- Insert securing rubbers - 1 - into lower section of E-Box.
- Clip lower section of E-Box with securing rubbers on pins - arrows - on vehicle.
• Sleeve seals for wires must be inserted into guides of E-Box.
• Wires must not be pinched when assembling upper and lower sections of E-Box.