Power Distribution Module: Service and Repair

Vehicle Electrical System Control Module (J519)

• If control module is being replaced, first perform work procedure => [ Vehicle Electrical System Control Module, Coding ] Programming and Relearning.

Removal

- Turn off the ignition and all electric consumers and remove the key.

- Remove lower storage compartment on driver's side. Refer to => Body Interior 68 Removal and Installation.

• The number of multi-pin harness connectors - 1 - at Vehicle Electrical System Control Module can deviate from the illustration depending on vehicle equipment.






- Release locking mechanisms of multi-pin harness connectors - arrows - and disconnect multi-pin harness connectors - 1 - from Vehicle Electrical System Control Module - 2 -.

- Remove Vehicle Electrical System Control Module - 2 - with wires connected to rear side out of bracket.

- Release locking mechanisms of multi-pin harness connectors - arrows - and disconnect multi-pin harness connectors - 1 - from Vehicle Electrical System Control Module - 2 -.






- Remove Vehicle Electrical System Control Module from vehicle.

Installation

Install in reverse order of removal.