Engine, Securing on Assembly Stand

Engine, Securing on Assembly Stand

Special tools, testers and auxiliary items required

• Lifting tackle (3033)

• Shop crane (VAS 6100)

• Engine and transmission holder (VAS 6095)

• Engine lateral bracket (T03001)

• Transport arm (T03002)

When performing work, secure the engine using the (T03001 ) to the (VAS 6095).

- Remove the transmission.

- Remove the clamp - 1 - for the wiring harness, remove the bolts - 3 - and remove the shield - 2 -.





- Disconnect the harness connectors - 1 and 2 - and remove the bracket - 3 - bolts - arrow -.





- Install the (T03002) as shown.





The pin - 1 - engages in the cylinder block. Tighten the knurled bolt - 2 - hand tight.

- Install the (T03001).





Tighten bolts - 1 and 3 - to 40 Nm, and bolt - 2 - to 25 Nm.

• Bolts are designed so that they cannot be lost.

• When removing, the (T03001) must be held at tension in the direction of withdrawal, otherwise the bolt - 1 - cannot be loosened.

- Engage the (3033) as shown and lift out the engine using the (VAS 6100) and the (VAG 1383A).





- Secure the engine on the (VAS 6095).