Front Bumper Cover

Front Bumper Cover

=> [ Front Bumper Cover ]

Front Bumper Cover

• Slight changes may have to be made to removal and installation procedures of front bumper cover, depending upon equipment installed in vehicle.

Removing





- Remove left and right front wheel housing liners. Refer to => [ Front Wheel Housing Liner ] Wheel Housing Liner.

- Remove bolts - 2 - from above out of lock carrier.

- Remove bolts - 1 - from below.

- Remove screws - 3 - (pointing upward) at left and right.

- Remove hex nuts - 4 - at left and right fenders on inside.

A second technician is required for the rest of the removal procedure.

- With a second technician, pull bumper cover parallel out of mounts of fender.

- Disconnect the hose coupling on the washer fluid hose.

Installation

To install, perform the steps used for removal in reverse order.

• When installing front bumper cover, make sure it is guided on parallel on fender.

- Pay close attention to the parallel alignment and the gap dimensions.