Ribbed Belt Pulley, Sanden

Ribbed Belt Pulley, Sanden

• It is not necessary to remove the A/C compressor when replacing the ribbed belt pulley.

• To loosen and tighten bolts, hold ribbed belt pulley firmly in place using a standard band wrench (with webbing).

• Removing ribbed belt.





1 Hex head nut

• Replace

• To loosen and tighten hex nuts, hold ribbed belt pulley firmly in place using a standard band wrench (with webbing).

• Install the hex nuts with locking compound (D 000 600 A2).

• 25 Nm

2 Screw

• To loosen and tighten hex nuts, hold ribbed belt pulley firmly in place using a standard band wrench (with webbing).

• Quantity: 3

• 4.5 Nm

3 Overload protection

• Bolted with to the ribbed belt pulley.

• Keeps the ribbed belt pulley from turning when the A/C compressor gets blocked.

• To loosen and tighten bolts, hold ribbed belt pulley firmly in place using a standard band wrench (with webbing).

4 Washer

5 Circlip

• Replace

• Install on proper side, beveled insertion edge - A - faces away from A/C compressor (install flat side facing the A/C compressor)

6 Ribbed belt pulley

• Clean A/C compressor flange before sliding on pulley.

7 A/C Compressor

• Sanden

• Clean the flange before mounting the ribbed belt pulley.