Steering Column Combination Switch (E595), Through 10.09

Steering Column Switch

Steering Column Combination Switch (E595), Through 10.09

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1410)

Removing:

- Disconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Remove the following components in order:

- Remove steering wheel.

- Remove steering column trim.

- Remove Steering Column Electronic Systems Control Module (J527). Refer to => [ Steering Column Electronic Systems Control Module, Through 10.09 ]. Steering Column Electronic Systems Control Module (J527), Through 10.09

- Remove Airbag Spiral Spring/Return Spring With Slip Ring (F138). Refer to => [ Airbag Spiral Spring/Return Spring With Slip Ring, Through 10.09 ]. Airbag Spiral Spring/Return Spring With Slip Ring (F138), Through 10.09

- Remove segment sensor for steering column sensor. Refer to => [ Steering Angle Sensor Segment Sensor, Through 10.09 ]. Steering Angle Sensor Segment Sensor, Through 10.09

- Remove both bolts - arrows - on top side of Steering Column Combination Switch.





- Pull off Steering Column Combination Switch toward rear from steering column.

Installing:

Install in reverse order of removal.

- Tighten all threaded connections to the specification shown in => [ Fastener Tightening Specifications, Steering Column Switch Assembly ] [1][2]Combination Switch.