Access/Start Authorization Antenna 2 in Vehicle Interior (R139)

Access/Start Authorization Antenna 2 in Vehicle Interior (R139)

The access/start authorization antenna 2 in vehicle interior is located underneath the center rear seat bench.

No coding, basic setting or adaptation is necessary if the access/start authorization antenna 2 in vehicle interior is replaced. Erase the entry in the DTC memory using the Vehicle diagnostic tester.

• Turn off the ignition and all electrical consumers.

• Remove the key.

Removing

- Remove the rear seat bench.

- Remove the access/start authorization antenna 2 in vehicle interior - 1 - vertically upward with a small screwdriver from the bonding - arrow -.






- Disconnect the connector - 2 - and remove the access/start authorization antenna 2 in vehicle interior - 2 - from the vehicle.

Installing

Install in reverse order of removal. Note the following:

- Clean the adhesive surface before installing the access/start authorization antenna 2 in vehicle interior.