Steering Column Electronics Control Module (J527), Valeo

Steering Column Electronics Control Module (J527), Valeo

Always follow the sequence when removing and installing steering column switch components. Refer to => [ Steering Column Switch Module Components, Removing and Installing Sequence ] Steering Column Switch Module Components, Removing and Installing Sequence.

• Risk of airbag deployment!

• The airbag unit could deploy if mishandled.

• Read the safety precautions when performing work on the airbag.

Always follow the instructions regarding disconnecting and connecting the battery. Refer to => [ Battery (A), Disconnecting and Connecting ] Battery (A), Disconnecting and Connecting.

Removing

- Disconnect the battery. Refer to => [ Disconnecting ] Disconnecting.

- Removing the steering wheel.

- Remove the steering column trim.

- Disconnect the connectors (depending on the vehicle equipment level) - 1 -, - 2 -, - 3 - and - 4 -.






• Do not twist the airbag spiral spring/return spring with slip ring (F138) on the steering column electronic systems control module out of its center position when removing it. The front wheels must be in the "straight-ahead position".

- Remove the screws - arrows - and remove the steering column electronic systems control module from the steering column switch.

Installing

Install in reverse order of removal. Note the following:

The return lever on the turn signal switch (E2) could break off when installing the steering column electronic systems control module.

The turn signal switch must be in the 0 position when installing the steering column electronics control module.

- Slide the steering column electronic systems control module onto the steering column switch.

- Tighten the threaded connections to the tightening specifications. Refer to => [ Steering Column Switch Module Overview, Valeo ] Steering Column Switch Module Overview, Valeo.

- Connect the battery. Refer to => [ Connecting ] Connecting.