Fog/Driving Lamp Bulb: Service and Repair

Fog Lamp

• Illustrations depict removal and installation of right fog lamp.

Removal

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Unclip the cover - 1 - at the latching mechanisms - arrows - from the bumper cover.






- Remove screw - arrow -.






- Pull the fog lamp housing - 1 - out of the mounts in the bumper cover - 2 - while paying attention to the connected wires and remove.

- Release and disconnect the harness connector - arrow - and remove the fog lamp housing.








Installation

Installation is performed in the reverse order of removal. Note the following:

- Tighten the mounting bolt to the tightening specification shown in=> [ Fog Lamps Overview ] Fog Lamps Overview.

- Check the fog lamp functions.

- Check the headlamp adjustment and correct it if necessary.