Oil Pump: Service and Repair

Oil Pump, Removing and Installing

Perform the following:

Removing

- Remove the oil pan. Refer to => [ Oil Pan, Removing and Installing ] Service and Repair.

- Remove the splash wall.

- Remove the bolt - 2 -.






- Remove the chain sprocket from the oil pump shaft.

- Remove the bolts- 1 - and - 3 - and the oil pump.

Installing

Installation is performed in the reverse order of removal. When doing this note the following:

- Mount the alignment sleeves on the upper part of the oil pump.

The chain sprocket can only be installed in one position.

- Replace the chain sprocket bolt.

• Tightening specifications: => [ Lubrication System Components, Assembly Overview ] Service and Repair

- Install the splash wall.

- Install oil pan => [ Oil Pan, Removing and Installing ] Service and Repair.