Plastic Relay Lever

Plastic Relay Lever

A plastic relay lever is installed from 05.07. Two versions may be installed.

• Relay lever with tab or

• Relay lever with clip

Note the following when removing and installing:

• To remove the relay lever, it is necessary to remove the cable retainer from the selector cable.

This prevents damage to the selector cable.

- Pull the securing mechanism all the way forward in the - direction of arrow 1 - and then unlock to the left in the - direction of arrow 2 -.





- Push the relay lever forward in the - direction of arrow 3 -.

Relay Lever with Tab





- Push the tab - arrow 1 - all the way down and remove the relay lever and cable retainer. Move the relay lever in its operating direction.

Relay Lever with Clip





- Remove the clip - arrow 1 - and then remove the relay lever and the cable retainer.

Continuation for All

• The cable retainer must be behind the tab - arrow 2 -.

• The cable retainer may only be removed with the relay lever removed.

• Lubricate the bearing areas and sliding surfaces when installing.

• For the correct grease, refer to the Parts Catalog.

- Press the cable retainer on the relay lever.

- Insert the relay lever together with the cable retainer as far as the stop.

Relay Lever with Tab





• The tab - arrow 1 - secures the relay lever.

• Make sure it engages securely.

• The cable retainer must be behind the tab - arrow 2 -.

Relay Lever with Clip





• The clip - arrow 1 - secures the relay lever.

• Make sure the clips locks securely.

• The cable retainer must be behind the tab - arrow 2 -.

Removing the Selector Cable Retainer from the Plastic Relay Lever





• The relay lever is removed.

- Insert a screwdriver - A - between the bushing - B - and the relay lever.



Installing the Cable Retainer





• The relay lever is removed.

• The cable retainer may only be installed at the bushing - arrow -.

• The cable retainer must move freely on the relay lever.

• It must be behind the tab - arrow 2 -.