Shift Knob with Boot and Noise Insulation

Shift Knob with Boot and Noise Insulation

Special tools, testers and auxiliary items required

• Hose Clamp Pliers (V.A.G 1275)

Removing

- Remove the boot with the center console cover from the center console or pry it out carefully - arrows -.





• On some equipment versions, you must pry out boot at front area.

- Fold the boot with the center console cover up over the shift knob.

- Open the clamp - arrow - and remove the shift knob and boot.





In some equipment versions, the center console cover remains in the center console.

- Pull the center console cover out or pry it out carefully.

- Remove the noise insulation - 1 -.





Installing

- Install the noise insulation.

Installed Location, Noise Insulation:





• - Arrow A - points in direction of travel.

• The tabs - arrows B - must latch into the center console.

- Press the center console cover into the center console.

- Then turn inner side of boot toward outside.

Install the shift knob all the way on.

- Install the shift knob with cover and boot and press the new clamp - arrow - together.





- Press the boot and the cover into the center console or press the boot into the cover.