RNS 315

RNS 315

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

• Replacement part number for Radio Navigation System (RNS) is located on a sticker on the radio housing.

• Always deactivate the electronic anti-theft code when replacing the RNS. Refer to => [ Electronic Anti-Theft
System, Deactivating ] RCD-310 Entry.

• If the radio code is not known, it can be retrieved via the known systems. The RNS serial number is needed. It is on a sticker on the side of the RNS housing. The serial number is also stamped into the side of the RNS itself.

• If an RNS from one vehicle is to be installed in another vehicle, make sure the RNS from both vehicles have the same replacement part number. Otherwise the navigation system will malfunction because rotation angle sensor setting in the RNS does not match the vehicle.

Removing


• Turn off the ignition and all electrical consumers.

• Remove the key.

- If there is a CD still in the unit, remove it. Refer to the Owner's Manual.

Only Jetta From MY 2011

- Remove the cover - 2 - from the instrument panel - 1 - using a (3409).






All Except Jetta From MY 2011

- Remove the vents from center of the instrument panel.

- Remove the screws - arrows -.






- Remove the trim from center of the instrument panel.

All Vehicles

- Remove screws - arrows -.






- Pull the radio/navigation display unit control module out of the installation slot just far enough until the connectors on the back are accessible.

- Squeeze the connector lock in direction of the - arrows -.






- Move the locking bracket in the direction of the - arrow - and remove the connector.






- Unlock the antenna connections - arrows - and disconnect the connectors.






Installing

Install in reverse order of removal. Note the following:

• Never push on the display or the buttons on the radio/navigation display unit control module when installing it. It will be damaged.

- Install the screws - arrows - in the radio/navigation display unit control module.






- Deactivate the electronic anti-theft coding. Refer to => [ Electronic Anti-Theft
System, Deactivating ] RCD-310 Entry.

- Check the radio/navigation display unit control module coding. Code it again if necessary. Refer to => [ RNS 315 Functions, Adapting ] RNS 315 Functions, Adapting.

Torque specifications: 1.5 Nm