Shift Cable and Selector Cable

Shift Cable and Selector Cable

Removing

- Remove the shift mechanism. Refer to => [ Shift Mechanism ] Shift Mechanism.

- Bend the tabs - arrows - on the shift mechanism cover using a screwdriver and remove the cover.





- Remove the gasket.

- Remove the lock washers - 2 and 3 -. The lock washers - 1 and 4 - are no longer installed. Pry off the shift cable (or the selector lever cable) from the shift lever guide (or selector bracket) with a screwdriver.





- Remove the shift cable and selector cable from the shift housing.

Release the retainers - A - for the shift and selector cables - B - as follows:





• Push the sleeve forward as far as it will go - arrow 1 -.

• Turn the sleeve to the right as far as it will go - arrow 2 - until it engages.

- Remove the retainers from the cables.

- Remove the lock washers - 1 and 2 -.





- Remove the cable from the bracket support.

Installing

Install in reverse order of removal.

- Secure the shift cable and selector cable to the shift housing with the lock washers - 2 and 3 -.





- Press the shift cable and selector cable onto the shift lever guide and selector bracket in the shift housing. Lock washers - 1 and 4 - are no longer installed.

- Install the gasket and press in the tabs - arrows - to secure the shift mechanism cover to the shift housing.





- Install the shift mechanism. Refer to => [ Shift Mechanism ] Shift Mechanism.

- Adjust the shift mechanism. Refer to => [ Shift Mechanism, Adjusting ] Adjustments.