Fluid - M/T: Service and Repair

Transmission Fluid Level, Checking

Special tools, testers and auxiliary items required

• Triple Square Socket Driver (3357)

• Torque Wrench (5-50 Nm) (V.A.G 1331)

For the correct fluid, refer to the Parts Catalog.

- Remove the noise insulation.

- Remove the plug - arrow - for checking the fluid level.






The level is correct when the fluid comes up to the bottom edge of the hole.

- Add fluid, if necessary, until it reaches the lower edge of the hole.

- If already assembled, install the plug - arrow - with a new seal.

- Tighten the plug - arrow - to specification. Refer to => [ Different Versions of the Oil Fill and Drain Plugs ].

Different Versions of the Oil Fill and Drain Plugs





I - Oil fill or drain plug with a multi-point socket head - 45 Nm

II - Oil fill or drain plug with a hex socket head - 30 Nm

- Install the noise insulation.