Cell Phone Operating Electronics Control Module (J412)

Cell Phone Operating Electronics Control Module (J412)

The Cell Phone operating electronics control module is located under the fright front seat.

Removing

- Move the right front seat into its highest position and the move it all the back.

- Turn off the ignition and all electrical consumers and remove the key.






- Pull the lever - 2 - for seat forward/backward adjustment up and hold it.

- Push the module carrier - 1 - for cell phone operating electronics control module - 3 - toward the outside in direction of arrow - A - and lift it on the tunnel in direction of arrow - B -.

- Remove the module carrier - 1 - for the cell phone operating electronics control module - 3 - in direction of arrow - C -.

- Turn over the module carrier - 1 - for the cell phone operating electronics control module - 3 -.






- Disconnect the connector - 3 - from the v - 2 -.

- Open the retainer - arrow - for the cell phone operating electronics control module - 2 - in the module carrier - 1 -.

- Remove the cell phone operating electronics control module - 2 - from the module carrier - 1 -.

Installing

Install in reverse order of removal.