Brake Pedal and Brake Booster, Separating and Connecting

Brake Pedal and Brake Booster, Separating and Connecting

Special tools, testers and auxiliary items required

• Release tool (T10159)

Separating

- Open the storage compartment - 2 - and remove it.






- Remove the bolts - arrows - and the trim panel - 1 - inside the driver footwell.

- Remove the diagnostic connection - 3 -.

- Disconnect the connector from the footwell lamp - 4 -, if equipped.

- First press brake pedal in direction of brake booster and hold.






2 Pressure rod
3 Retaining lugs

- Insert the (T10159) and pull it toward the driver seat while applying counter pressure against the brake pedal.

• The pedal assembly must not move toward the rear while doing this.

• This will cause the tabs - 3 - to be pushed out of the push rod ball head mount- 2 -.

- Pull (T10159) and brake pedal together toward the driver seat.

This will pull the brake pedal off.

Connecting






- Hold the push rod ball head in front of the mount and push the brake pedal toward the brake booster until the ball head engages audibly.

- Check the lock by pulling on the brake pedal.